On-Board® W Module Programming and Operation ... - PTB Sales
On-Board® W Module Programming and Operation ... - PTB Sales
On-Board® W Module Programming and Operation ... - PTB Sales
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Programming</strong> <strong>and</strong> <strong>Operation</strong><br />
CTI-CRYOGENICS<br />
HELIX TECHNOLOGY CORPORATION<br />
REGEN Setup<br />
The thirteenth parameter of the REGEN function allows the user to establish<br />
the presence of a purge valve or a rough valve on the <strong>On</strong>-Board<br />
Waterpump. The <strong>On</strong>-Board <strong>Module</strong> will automatically provide the appropriate<br />
regeneration sequence for the in-line, appendage, or cryopanel<br />
waterpumps. The REGEN Setup display is shown in Figure 3-22.<br />
REGEN SETUP<br />
Last<br />
1 2 3<br />
MONITOR<br />
CONTROL<br />
Next<br />
4 5 6<br />
REGEN<br />
RELAYS<br />
Clear<br />
7 8 9<br />
SERVICE<br />
HELP<br />
- 0 .<br />
Enter<br />
ON-BOARD<br />
oo<br />
®<br />
Figure 3-22: REGEN Setup Display<br />
REGEN Function <strong>Programming</strong><br />
Use the following procedures to program the REGEN function parameters<br />
of the <strong>On</strong>-Board W <strong>Module</strong>.<br />
Initiate REGEN<br />
1. Press the REGEN key on the keypad/display. The current<br />
REGEN status is displayed.<br />
2. Press 1 to initiate a regeneration cycle.<br />
3. Press 2 to confirm the start of a regeneration cycle. Regeneration<br />
has been initiated.<br />
Abort REGEN<br />
1. Press the REGEN key on the keypad/display. The current<br />
REGEN status is displayed.<br />
2. Press 0 to abort the regeneration cycle.<br />
3. Press 2 to confirm the end of a regeneration cycle. Regeneration<br />
has been aborted.<br />
3-16 P/N 8040365
Change language