On-BoardÂ® W Module Programming and Operation ... - PTB Sales

More documents

Recommendations

Info

On-Board W Module Programming and Operation CTI-CRYOGENICS HELIX TECHNOLOGY CORPORATION Table C-1: RS-232 REGEN Responses and Descriptions (Continued) REGEN Response V REGENERATION ABORTED Description Command e displays the reasons for regeneration abort. The messages are as follows: @ - No error A,B - WARM-UP TIMEOUT - Did not reach warm-up temperature within 150 minutes. C - COOLDOWN TIMEOUT - Did not cool down within 4 hours. E - ROR CYCLE LIMIT WAS REACHED - The pump did not pass the rate-of-rise test within the programmed cycle limit. F - MANUAL ABORT - Someone manually gave the command to stop regeneration. G - ROUGH VALVE TIMEOUT - Rough valve was opened for more than 1 hour without closing. W,p DELAY RESTART This countdown timer delays starting the pump for cooldown mode after it has been warmed up, roughed out, and passed the ROR test. This is a user programmed value. If the pump has no valves, the delay timer begins when the pump reaches 310K. To get the timer value in minutes, use the command k. Display the time in hours. X POWER FAILURE There was a power failure during the regeneration cycle and the pump will make a decision to cooldown or regenerate. This display should last for no longer than one second. Y POWER FAILURE COOLDOWN There was a power failure during regeneration but the pump is continuing to cool down. Refer to Appendix D - Power Failure Messages. P/N 8040365 C-5
Appendix C - RS-232 REGEN Responses CTI-CRYOGENICS HELIX TECHNOLOGY CORPORATION Table C-1: RS-232 REGEN Responses and Descriptions (Continued) REGEN Response Description Z, \ DELAY START The start of regeneration will be delayed for some time. The time of this delay is the command k. This will give the time in minutes. Display it in hours. [ Zeroing TC GAUGE. The TC gauge is being zeroed at the end of regeneration. C-6 P/N 8040365
Page 1 and 2:
CTI-CRYOGENICS HELIX TECHNOLOGY COR
Page 4 and 5:
On-Board W Module Programming and O
Page 6 and 7:
Page 8 and 9:
Page 10 and 11:
Page 12 and 13:
Page 14 and 15:
Page 16 and 17:
Page 18 and 19:
Page 20 and 21:
Page 22 and 23:
Page 24 and 25:
Page 26 and 27:
Page 28 and 29:
Page 30 and 31:
Page 32 and 33:
Page 34 and 35:
Page 36 and 37:
Page 38 and 39:
Page 40 and 41:
Page 42 and 43:
Page 44 and 45:
Page 46 and 47:
Page 48 and 49: On-Board W Module Programming and O
Page 80 and 81: Appendix A - Customer Support Infor
show all

On-BoardÂ® W Module Programming and Operation ... - PTB Sales

Create successful ePaper yourself

Delete template?

Save as template?