On-Board® W Module Programming and Operation ... - PTB Sales
On-Board® W Module Programming and Operation ... - PTB Sales
On-Board® W Module Programming and Operation ... - PTB Sales
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>On</strong>-Board W <strong>Module</strong> <strong>Programming</strong> <strong>and</strong> <strong>Operation</strong><br />
CTI-CRYOGENICS<br />
HELIX TECHNOLOGY CORPORATION<br />
DLY RESTART 20.5 HRS.<br />
Last<br />
1 2 3<br />
MONITOR<br />
CONTROL<br />
Next<br />
4 5 6<br />
REGEN<br />
RELAYS<br />
Clear<br />
7 8 9<br />
SERVICE<br />
HELP<br />
- 0 .<br />
Enter<br />
ON-BOARD<br />
oo<br />
®<br />
Figure 3-12: Delay Restart Display<br />
Repurge<br />
The fourth parameter of the REGEN function allows the user to establish<br />
the length of repurge time (in minutes) as shown in Figure 3-13. The<br />
waterpump will automatically be repurged if the pump fails to rough out to<br />
the user determined base pressure.<br />
2 MIN. REPURGE<br />
Last<br />
1 2 3<br />
MONITOR<br />
CONTROL<br />
Next<br />
4 5 6<br />
REGEN<br />
RELAYS<br />
Clear<br />
7 8 9<br />
SERVICE<br />
HELP<br />
- 0 .<br />
Enter<br />
ON-BOARD<br />
oo<br />
®<br />
Figure 3-13: Repurge Display<br />
Repurge Cycles<br />
The fifth parameter of the REGEN function allows the user to determine<br />
the number of repurge cycles that are performed if the pump fails to rough<br />
out to the user determined base pressure as shown in Figure 3-14. Regeneration<br />
is aborted after this limit is reached.<br />
P/N 8040365 3-11