On-Board® W Module Programming and Operation ... - PTB Sales

On-Board W Module Programming and Operation
CTI-CRYOGENICS
HELIX TECHNOLOGY CORPORATION
Vertical Scroll Display Keys (Last, Next)
The Last and Next keys allow the user to display the preceeding or
proceeding messages of the respective module software. Refer to the
flowcharts in Section 3 - Programming and Operation for more
information on the messages.
Clear Display Key
The Clear key is used to remove user entered information during On-Board
module programming or device selection.
NOTE: The Clear key must be pressed before the Enter key is pressed to
remove the desired information.
Numeric Keypad
The numeric keypad is used to enter numeric values for On-Board Module
programming and operation.
Enter Command Key
The Enter key is used to accept numeric information which the user has
entered via the numeric keypad.
Function Keys
The function keys allow the user to select the software function in which
programming or operation is desired. Refer to Section 3 - Programming
and Operation for more information on software functions.
On-line Help
The on-line HELP function provides the user with additional information
when used in conjunction with the MONITOR, REGEN, SERVICE,
CONTROL, and RELAYS function keys. Ranges of programmable values
are displayed when the HELP key is pressed after the Enter key has been
pressed. ON/OFF values are also displayed at appropriate times.
Instructions are also displayed for certain messages that appear on the
screen. Figure 1-2 shows a help message that might be displayed, line by
line, in the keypad/display when the HELP key is pressed during warm-up
in the regeneration cycle.
P/N 8040365 1-3