SunTouch® - Pentair
SunTouch® - Pentair
SunTouch® - Pentair
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
15<br />
Heat Menu (2/14) (Continued)<br />
Spa Temperature and Heat Source<br />
To set the SPA temperature and switch the HEATER ON or OFF:<br />
Main Menu 2/14<br />
Heat<br />
Spa Temperature<br />
Temp: 85°F<br />
Spa Heat Source<br />
Heat: Heater<br />
Menu > Right arrow button: Select the Heat settings.<br />
Right/Left arrow button: Select the SPA temperature setting.<br />
Up/Down arrow button: Adjust to the desired spa set point temperature<br />
(from 40° F to 104° F or 4° C to 40° C).<br />
Right arrow button: Access the POOL HEAT source setting.<br />
Up/Down arrow button: Select the heat source options: OFF, HEATER, SOLAR<br />
PREFERRED or SOLAR.<br />
Left arrow button: Press the Left button to return to the main status screen.<br />
HI-TEMP (Up Arrow button)<br />
For SunTouch single body systems (pool only or spa only, see page 36), the HI-TEMP (UP arrow button) is<br />
used to switch the heater (regardless of the Heat menu setting) and filter pump on and off. Typically this<br />
circuit is used with the “Manual Heat” feature (see below) for on-demand spa water heat. The heat<br />
temperature settings are displayed on the main screen. The heater is active when the set temperature is higher<br />
than the water temperature. The heater will switch off when the water temperature rises above the set<br />
temperature.<br />
LO-TEMP (Spa) Menu Operation<br />
The LO-TEMP on and off control is made from the Heat menu setting. For SunTouch single body systems<br />
(pool only or spa only, see page 36), the LO-TEMP menu setting is used to switch on and off the heat source<br />
and filter pump. A heat selection must be selected in the Heat menu before the heater is activated. The<br />
“Manual Heat” setting does not function with the LO-TEMP circuit. The heater is active when the set<br />
temperature is higher than the water temperature. The heater will switch off when the water temperature<br />
rises above the set temperature.<br />
MANUAL HEAT (Off/On)<br />
By default, the spa Manual Heat feature is always set to “ON.” This allows the spa to begin to heat whenever<br />
the SPA, Up arrow button is pressed, regardless of the heat source setting in the Heat menu (see page 4).<br />
This feature allows the spa to be filtered daily with the heater switched off. The optional QuickTouch QT4<br />
wireless remote can also be used to switch the spa heater on. This feature will not work for solar systems,<br />
only gas and electric heaters.<br />
MANUAL HEAT<br />
To enable or disable spa heat when switched on manually:<br />
Main Menu 2/14<br />
Heat<br />
Manual Heat<br />
Manual Heat: On<br />
Menu > Right arrow button: Select the Heat settings.<br />
Right/Left arrow button: Select the MANUAL HEAT setting.<br />
Up/Down arrow button: Select OFF to disable or ON to automatically activate the<br />
heat when the SPA, Up arrow button (or HI-TEMP button for single body<br />
systems) is pressed regardless of the “Heat Source” setting (see page 14).<br />
Left arrow button: Press the Left arrow button to return to the main status screen.<br />
SunTouch Solar, Pool and Spa Control System Installation and User’s Guide
Change language