SunTouch® - Pentair

29
To select a single-speed pump.
Main Menu 12/14
Pumps
Pump Type
[SINGLE SPEED]
Menu button > Right button: Select the Pumps 9/14 menu.
Right button: Press the button to select the pump settings.
Up/Down buttons: Select Single Speed. A single-speed pump has no assigned
circuit. The pool filter schedule determines when the pump is switched on and off. For
more information, see Schedules Menu on page 17.
Right button: Press this button to exit to the main menu items.
Left button: Press the Left button to return to the main status screen.
TWO SPEED FILTER PUMP
Note: There must be a two-speed relay installed in the SunTouch enclosure in order for the “Two-
Speed” pump menu feature to operate. The two-speed relay circuit can assigned to AUX 1, AUX 2, AUX
3 or FEATURE 1 - 4. This allows the pump to operate at low speed when required.
Assigned circuits will automatically switch a two-speed filter pump to high speed when these circuits are
switched on setup in the Schedules menu. If a two-speed pump is assigned to solar, a cleaner or a pump, when
activated the pump will automatically run for five minutes in high speed then switch to low speed. For
example, when on, the filter pump will switch to high speed whenever the JETS or CLEANER is on.
Main Menu 12/14
Pumps
Pump Type
[TWO SPEED ]
Pump Circuits
1 - [POOL ]
Pump Circuits
2 - [SPA ]
Pump Circuits
3 - [HEATER ]
Pump Circuits
4 - [FREEZE ]
Menu button > Right arrow button: Select the Pumps 12/14 menu.
Right button: Press this button to select the Pump Type.
Up/Down buttons: Select TWO SPEED.
Right button: Select Pump Circuits. You can assign up to four (4) 2-speed pump
circuits and eight (8) IntelliFlo pump circuits.
Up/Down buttons: Select up pump circuits. The pump circuit selections are: NONE,
SPA, POOL, AUX 1, AUX 2, AUX 3, FEATURE 1 - 4, SOLAR, HEATER,
FREEZE, POOL/SPA, and SOLAR/HT (solar/heater). Note: Selecting “Pool/Spa”
or “Solar/HT” combines several circuits into the same pump speed for pool and
spa or for solar and heater combination systems. Normally this would require
programming two separate pump speeds for each function. Using one of these
selections free-up one of the four pump speed for other uses.
Right button: Select the second circuit settings for the pump. Use the Up/Down
buttons to select the circuit. If necessary, repeat this process to assign the third and
fourth circuit for the pump.
Left button: Press the Left button to return to the main status screen.
SunTouch Solar, Pool and Spa Control System Installation and User’s Guide