SunTouch® - Pentair
SunTouch® - Pentair
SunTouch® - Pentair
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
81<br />
Commercial Application using ESO3 and SunTouch (Single Body System)<br />
Using a Emergency Shut-Off Switch (ESO3), circuit board, and a spring wound timer switch (Intermatic ® or<br />
equivalent), a SunTouch single body system (P/N 520859) can be configured for a commercial application. A<br />
typical configuration, using a single speed pump is shown in the “Commercial Application Connection Diagram”<br />
below. As shown, the commercial spa jet pump is controlled by the spring wound timer switch and AUX 1 (Jet<br />
pump) is programmed by SunTouch to operate from 5:00 AM to 12:00 AM. When the Emergency Shut-Off<br />
Switch is pressed, both relays will disengage. If the pool or spa light is controlled by AUX 2, the light will remain<br />
operational.<br />
SunTouch for commercial<br />
appliction with IntelliFlo<br />
VS+SVRS<br />
and IntelliFlo VSF+SVRS pump<br />
IntelliFlo VS+SVRS and<br />
VSF+SVRS filter pump is<br />
controller by SunTouch<br />
Internal time clock AUX 1<br />
(VS+SVRS Jet Pump) in this<br />
applicatin will be<br />
programmed to operate during<br />
the hours of operation (e.g. 5:00<br />
AM - 12:00 AM).<br />
When Emergency Switch is<br />
pressed, both relays disengaged.<br />
If the pool or spa<br />
light are controlled by AUX 2 light<br />
will remain on. For use with single<br />
speed pumps<br />
or IF VS+SVRS.<br />
CR2032<br />
+3V<br />
GAS<br />
HEATER<br />
J12<br />
RESET<br />
SunTouch<br />
Motherboard<br />
P/N 520859<br />
Pool or Spa Light<br />
INTAKE RETURN SOLAR PUMP AUX 1 AUX 2 AUX 3<br />
VLV A VLV B VLV C<br />
VALVE ACTUATORS<br />
SOLAR<br />
ONLY<br />
CLNR<br />
ESO Emergency<br />
Shut Off Switch<br />
IntelliFlo VS+SVRS<br />
/VSF-SVRS<br />
Jet Pump<br />
Relay<br />
F J13<br />
F<br />
LINE VOLTAGE<br />
E<br />
E<br />
Note: Spring wound timer must be a<br />
DPST switch. Both legs of<br />
power must be turned OFF. For IntelliFlo<br />
VS+SVRS/VSF+SVRS,<br />
disable “Priming” feature.<br />
AUX (Filter Pump)<br />
AUX 1<br />
AUX 2<br />
(POOL or<br />
SPA Light)<br />
+ -<br />
D<br />
SHUT OFF<br />
D<br />
C<br />
C<br />
B<br />
ESO Module<br />
LINE VOLTAGE<br />
B<br />
A<br />
A<br />
520106 520106<br />
Required Parts:<br />
1. P/N 520859<br />
SunTouch Single<br />
Body<br />
2. P/N ES03<br />
Emergency Shut Off<br />
3. Spring Timer (P/N<br />
FF4 15M, FF4 30M,<br />
FF4 60M)<br />
Note: Spring wound<br />
timer (DPS) for<br />
booster jet pump must<br />
be rated for proper<br />
amperage.<br />
IntelliFlo VS+SVRS<br />
/VSF-SVRS<br />
Filter Pump<br />
Relay<br />
LINE VOLTAGE<br />
LINE VOLTAGE<br />
Commercial Spa Jet Pump<br />
(For IntelliFlo VS+SVRS/VSF+SVRS,<br />
disable PRIMING feature)<br />
Spring Wound<br />
Timer Switch (DPST)<br />
WhisperFlo® Filter Pump<br />
(or IntelliFlo VS-SVRS/VSF-SVRS)<br />
SunTouch Solar, Pool and Spa Control System Installation and User’s Guide