SunTouch® - Pentair

35
Pump Menu (12/14) (Continued)
IntelliFlo ® VSF+SVRS pump
From the IntelliFlo VSF+SVRS menu you can assign circuits to control the pump flow rate (GPM/RMP),
priming, also filter, backwashing, vacuum functions and view the current pump status. For more information
about the IntelliFlo VS, refer to the IntelliFlo VF Installation and User’s Guide (P/N 350075).
To assign up eight (8) pump speeds and circuits for the IntelliFlo VS pump:
Main Menu 12/14
Pumps
Pump Type
[INTELLIFLO VF ]
Pumps Parameters
Menu: CIRC. SETUP
Circuit Setup
1 - [ POOL ]
Assign Circuit
1 - [SPA ]
GPM/RPM Mode
GPM (RPM)
Assign Flows
1 - GPM: 80
Assign PSI
1 - PSI: DSBL
Assign Flows
1 - GPM: PSI
Assign Speeds
1 - RPM: 7710
Menu button: Select the Pumps 12/14 menu.
Right button: Press the button to view the type of pump to select.
Up/Down buttons: Select IntelliFlo VF them press Right button again to select.
Press Up/Down buttons to view the Pump Parameters menus: CIRC. SETUP,
and STATUS. Press Right button to choose one of the parameters.
CIRCUIT SETUP: Press Right button to assign a circuit to the pump. Press Up/
Down buttons to view the circuits for the first of eight (8) pump circuits: [NONE,
SPA, POOL, AUX 1, AUX 2, AUX 3, FEATURE 1-4, SOLAR, HEATER,
POOL HEAT, SPA HEAT, FREEZE, POOL/SPA, and SOLAR/HT (solar/
heater)].
GPM/RPM Mode: Press the Right button to set the GPM and RPM pump speed.
Press Up/Down button to toggle between RPM and GPM/PSI.
The Assign Flows screen displays. Press Up/Down buttons to set the pump flow
rate from 15 - 130 GPM. The default flow rate is 30 GPM. The preset speed for each
button is: Speed 1 button 1100 RPM (30 GPM), Speed 2 button 1500 RPM,
Speed 3 button 2350 RPM, and Speed 4 button 3110 RPM.
Press the Right button again to set the PSI setting. Press Up/Down buttons to set
pump pressure setting from 1 to 30 PSI.
Press Right button to select the circuit. Note: Selecting “Pool/Spa” or
“Solar/HT” combines several circuits into the same pump speed for pool and
spa or for solar and heater combination systems. Normally this would require
programming two separate pump speeds for each function. Using one of these
selections, free-up one of the four pump speed for other uses.
Press Right button to continue to assign pump FILT. CIRC. and CIRCUITS. You
can assign up to eight (8) pump speeds and circuits.
When finished assigning pump flow rate and circuits, press the Right button until
FLOWS is displayed, then press the Up/Down buttons and select FILTER.
Press Right button to select Assign Flows. Press the Up/Down buttons to set the
flow rate from 15-150 GPM.
Press Right button to select Assign PSI. Press the Up/Down buttons to set the
pressure rate from 1-30 PSI.
Left button: Press the Left button to return to the main status screen.
SunTouch Solar, Pool and Spa Control System Installation and User’s Guide