V750-series UHF RFID System User's Manual - PLCeasy

3.1.5.3 Communication Settings
To set the conditions to communicate with tags, following items shall be specified in the SET Communication
command (SETC) and GET Communication command (GETC). Specifying following option allows the reader
to set or read the communication condition. To write the setting data into the nonvolatile memories in the
reader, SAVE command (SAVE) shall be executed.
Communication Settings [RF Control] (GETC/SETC)
Code Content User Setting Value Factory Settings
PW1 UHF power level at port #1 Given value
31.5 (dBm)
-Min: 10.0
-Max: 31.5
-Step: 0.5
PW2 UHF power level at port #2 Same as PW1 31.5 (dBm)
PW3 UHF power level at port #3 Same as PW1 31.5 (dBm)
PW4 UHF power level at port #4 Same as PW1 31.5 (dBm)
SS1 Gen2 Session value #1
Choice
0
In case of Once Mode sequence
SS2 Gen2 Session value #2
In case of Repeat Mode
sequence
0 / 1 / 2 / 3
Choice
0 / 1 / 2 / 3
CMD Communication mode Choice
0: Normal mode
EWL EPC word length Given value
-Min : 0
-Max : 32
-Step : 1
1: Dense reader mode (DRM)
2
0: Normal mode
0 : Auto mode
Communication Settings [Filtering] (GETC/SETC)
Code Content User Setting Value Factory Settings
FTE Filtering enable Choice
0:None
0: None
1: Filter1 only
2: Filter2 only
1&2: Filter1 and Filter2
1|2: Filter1 or Filter2
FT1 Filtering condition #1 Format:
(None)
FileterType(S)MemBank(S)Point
er(S)Length(S)Value
FilterType: 0 (fixed)
MemBank: 0 to 3
Pointer: 0 to 255 (bit)
Length: 1 to 255(bit)
Value: XXXX…
-Note: Set longer bits than the
bits specified in the “Length” with
2-digit hexadecimal number (“0”
to “F”). Max: 64 characters. The
most significant bit is a Pointer of
the Value.
FT2 Filtering condition #2 Same as FT1 (None)
Communication Settings [Smoothing] (GETC/SETC)
Code Content User Setting Value Factory Settings
SBF Prevents repeat read -Min: 0 (Disable) 0:Disable
78 of 135