V750-series UHF RFID System User's Manual - PLCeasy
V750-series UHF RFID System User's Manual - PLCeasy
V750-series UHF RFID System User's Manual - PLCeasy
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Operation Settings [Programmable Output] (GETO/SETO)<br />
Code Content User Setting Value Factory Settings<br />
OT1 Output port #1 function<br />
setting<br />
Format: Timing(S)OutputTime(S)Condition (None)<br />
Timing<br />
00:None<br />
(User input)<br />
11:RUN output<br />
(The reader is running normally.)<br />
12:ERR output<br />
(The reader stopped with error.)<br />
20:COM output<br />
(The reader is communicating.)<br />
2n:ATn Current antenna(s) (n=1 to 4)<br />
(The reader is communicating<br />
with specified antenna)<br />
31:NML<br />
(Evaluated normal completion)<br />
32:ERC<br />
(Evaluated completion with error<br />
occurring)<br />
OutputTime<br />
10 to 9990 [ms]<br />
0 (Status kept until upcoming evaluation.)<br />
- Note: Output time is effective only for NML/<br />
ERC setting.<br />
OT2<br />
OT3<br />
OT4<br />
Output port #2 function<br />
setting<br />
Output port #3 function<br />
setting<br />
Output port #4 function<br />
setting<br />
Condition<br />
-Note: Output time is effective only for NML/<br />
ERC setting.<br />
- Note: If the condition is omitted, output<br />
signal shall be on without condition.<br />
* Refer to the following list.<br />
Same as OT1<br />
Same as OT1<br />
Same as OT1<br />
(None)<br />
(None)<br />
(None)<br />
83 of 135
Change language