Load Catalogue (PDF, 58 MB) - Schuch

Polyester Damp Room Emergency Light Fittings
without Diffusers
Series 175...
Application:
In workshops and to illuminate and indicate
escape routes according to DIN V
VDE V0108-100 and EN 1838.
Mechanical design:
Enclosure: glass fibre reinforced polyester
with press-in studs.
Seal: weather, ageing and chemical resistant
profile seal.
Electrical components: mounted inside
on the removable back plate of the light
fitting. Starter easily accessible from outside.
Damp room lamp holders with double
slotted contacts and neoprene gasket.
Electrical connection: 3-pole connection
terminal.
Through wiring: up to 5 x 2,5mm² possible.
Cable entries: variable, at the ends and
top of the housing, also available for looping
in/out at one end, 2 x blanking
plugs M20.
Mounting system: pre-pressed holes for
direct ceiling mounting. Rubber gaskets
for sealing are supplied with the fitting.
Wiring diagram 175 1... maintained operation
light switch
Battery conductor
Electrical design:
Built-in NiCd battery, a constant trickle
charge to the battery ensures readiness
of operation at all times.
Visual function monitoring the battery
charging process with LED.
Electronic deep discharge protection
Recharging time: 24 hours acc. to EN
60598-2-22.
Modes of operation:
Maintained mode = change-over to battery
operation on mains failure. With the
2-lamp version, only one lamp is operated
as emergency lighting (Series 175 2).
Mains voltage: 230V, 50Hz
Ambient temperature:
-5°C to +30°C for maintained mode
-5°C to +40°C for stand-by mode
Wiring diagram 175 2... maintained operation
light switch
emergency light fitting
Battery conductor
emergency light fitting
Starting: Connect battery conductor
Out of operation:
Disconnect battery conductor
Stand-by operation: Do not connect L1'
175 ...
with self-contained battery
T 26
Type Article no. Lamps/ Flux factor Weight
W about % 2) about kg 4)
1 h operation time, with conventional ballast
175 158/../. 175 136/18/1 17510 0005 1 x T 26/36 W 18 2,7
175 158/15/1 17510 0006 1 x T 26/58 W 15 3,2
175 236/18/1 3) 17510 0007 2 x T 26/36 W 18 4,6
175 258/15/1 3) 17510 0008 2 x T 26/58 W 15 5,7
1 h operation time, with electronic ballast (EVG)
175 136/18/1 EVG 17510 0009 1 x T 26/36 W 18 2,3
175 158/15/1 EVG 17510 0010 1 x T 26/58 W 15 2,5
175 236/18/1 EVG 17510 0011 2 x T 26/36 W 18 3,2
175 258/15/1 EVG 17510 0012 2 x T 26/58 W 15 2,6
1) Only uncompensated
2) Ratio effective lamp flux to rated current
IP65
3) Version for 3 h operating duration not possible
4) Weights without packing material
Series 175 1.. Series 175 2..
Bitte Subject beachten to technical Sie die changes, Hinweise im misprints Technischen and Anhang! errors.
Technische Änderungen, Druckfehler und Irrtümer vorbehalten.
276