1956 AMC Hudson Technical Service Manual Supplement
1956 AMC Hudson Technical Service Manual Supplement
1956 AMC Hudson Technical Service Manual Supplement
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
98 TECHNICAL SERVICE MANUAL<br />
Install driven torus on main shaft (Fig. 141)<br />
FIGURE 139—Installing Proper Selective Washer<br />
be indexed with splines of front unit driven torus shaft.<br />
Install sun gear over front unit driven torus shaft, chamfered<br />
side first.<br />
Install steel backing washer and bronze thrust washer<br />
against sun gear.<br />
Install drive torus member on intermediate shaft indexing<br />
front unit planet carrier with sun gear and internal gear.<br />
Secure drive torus to intermediate shaft with Truarc<br />
snap ring (Fig. 140).<br />
FIGURE 141—Installing Driven Torus<br />
Install driven torus front Truarc snap ring on main shaft to<br />
secure torus member.<br />
Install flywheel "0" ring seal on flywheel. Position<br />
flywheel against torus cover, indexing with dowels.<br />
(Flywheel can be installed in only one position since the<br />
dowels are of different sizes.)<br />
Install and tighten to 25 foot pounds torque, 18 flywheel<br />
to torus cover nuts leaving six of the nuts off the bolts (Fig.<br />
142). These six bolts will be used for attaching the flywheel<br />
and torus cover to the engine flex plate.<br />
FIGURE 140—Installing Drive Torus Snap Ring<br />
Install driven torus rear Truarc snap ring on main shaft.<br />
l. Flex Plate Attaching Bolts<br />
FIGURE 142—Installing Flywheel
Change language