1956 AMC Hudson Technical Service Manual Supplement
1956 AMC Hudson Technical Service Manual Supplement
1956 AMC Hudson Technical Service Manual Supplement
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
76 TECHNICAL SERVICE MANUAL<br />
Remove outer race, sprag and retainer by rotating clockwise<br />
and pulling upward (Fig. 70).<br />
1. Rear Sprag Outer Race 3. Rear Sprag Inner Race<br />
2. Sprag Assembly<br />
FIGURE 70—Removing Rear Unit Sprag Assembly<br />
l. Selective Thrust Washer<br />
FIGURE 68—Removing Output Shaft from<br />
Reverse Drive Flange<br />
small tool into small elongated hole in end of spiral ring and<br />
pull upward (Fig. 69).<br />
CAUTION: Do not attempt to disassemble sprag<br />
assembly.<br />
Remove rear unit sprag retainer and sprag.<br />
Disassemble rear unit clutch piston assembly by placing<br />
cylinder and piston assembly over tool J-6129 with spring<br />
end "up." Set spring compressor tool J-4670 on top of<br />
spring retainer and start nut on stud of tool J-6129.<br />
NOTE: On special tool J-4670, without hole in middle,<br />
drill a 7/16" hole so tool 1-6129 can be inserted<br />
through it. Compress clutch springs until snap ring is<br />
free and remove snap ring (Fig. 71).<br />
1. Tool J-4670 2. Tool J-6129<br />
FIGURE 69—Removing Spiral Snap Ring from<br />
Inner Race<br />
FIGURE 71—Removing Rear Unit Clutch Spring<br />
Snap Ring