1956 AMC Hudson Technical Service Manual Supplement
1956 AMC Hudson Technical Service Manual Supplement
1956 AMC Hudson Technical Service Manual Supplement
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
66 TECHNICAL SERVICE MANUAL<br />
torus cover assembly. Remove torus cover assembly by<br />
working hub of torus cover back through oil seal. Carefully<br />
pull torus cover out with even pressure to prevent damage<br />
to oil seal.<br />
Remove selective spacer washer from front unit driven<br />
torus hub. (Spacer may have remained in internal gear,<br />
Figure 33.)<br />
NOTE: If front unit coupling steel thrust washer<br />
adheres to bushing in housing, it should be removed<br />
to prevent it from dropping out and being<br />
damaged.<br />
Remove front seal protector and housing to case "0" ring<br />
seal from rear side of housing.<br />
Install transmission holding fixture J-6115 to transmission<br />
case. Position so that supporting arm of stand is over transmission.<br />
Use flywheel rear housing attaching screws<br />
threaded through small holes in fixture (Fig. 35).<br />
FIGURE 33—Removing Front Unit<br />
Selective Spacer<br />
Install front seal protector, J-6119 over intermediate shaft<br />
to protect the front oil seal and bushing when removing the<br />
flywheel housing (Fig. 34).<br />
FIGURE 35—Transmission Mounted<br />
in Holding Stand<br />
Install transmission into bench collet. \<br />
CAUTION: Use care to prevent front unit from<br />
sliding out of transmission and falling on floor.<br />
Position transmission horizontally with oil pan up<br />
and install lock handle in bench collet.<br />
CHECKING MAIN SHAFT END PLAY<br />
1. Front Seal Protector J-6119<br />
FIGURE 34—Front Seal Protector in Position<br />
Remove bolts and washers holding flywheel housing<br />
assembly to front end of transmission case. Remove flywheel<br />
housing assembly gently over front seal protector.<br />
To check main shaft end play, install collar of end play<br />
checking fixture J-6127 on main shaft and secure it in<br />
position by installing Truarc snap ring (Fig. 36).<br />
Attach fixture J-6127 to collar by threading collar securely<br />
into fixture.<br />
Install dial indicator support J-6126 and dial indicator<br />
(Fig. 37).<br />
Move main shaft back and forth to check end play of<br />
main shaft. End play should be .004" to .018". Be sure to get<br />
free main shaft end play. Forcing main shaft will give<br />
inaccurate reading.<br />
NOTE: Record amount of end play.<br />
Remove dial indicator, support, and end play checking<br />
fixture.
Change language