1956 AMC Hudson Technical Service Manual Supplement

HYDRA-MATIC TRANSMISSION 73
assembly, and inner steel washer from case by sliding
toward center of case. Remove steel washer and "0" ring
from case.
PARKING PAWL AND LINKAGE
REMOVAL
NOTE: These parts should not be removed unless
they are to be replaced.
Thread a 3/8" cap screw into the parking pawl pivot shaft,
then use the screw to work (or slide) the pivot shaft out of
the case (Fig. 60). Remove cap screw from pivot shaft.
FIGURE 58—Removing Low Band from
Case
FIGURE 60—Removing Parking Pawl Pivot Shaft
1. Snap Ring
FIGURE 59—Detent Lever Retaining Snap Ring.
Unhook parking pawl spring; slide bracket and spring
from shaft.
Remove washer from shaft.
Rotate pawl upward and slide pawl and linkage from shaft.
Remove parking pawl spacer washer from case
SUBJECT
DISASSEMBLY OF:
Case Support, Neutral Clutch, and Rear Unit
Front Unit Coupling
Front Pump
Rear Pump
Servo and Accumulator
Governor
Control Valve
Overrun Clutch Valve Body
Shift Valve Body
Reverse Blocker Assembly
Manual Valve Body
Pressure Regulator
Torus Check Valve from Driven Torus
PAGE
SUBJECT
DISASSEMBLY AND ASSEMBLY OF INDIVIDUAL UNITS
CONTENTS
74
OF THIS SECTION.
81
83
86
87
88
88
88
89
90
91
91
91
ASSEMBLY OF:
Rear Unit, Neutral Clutch, and Case Support
Front Unit Coupling
Front Pump
Rear Pump
Servo and Accumulator
Governor
Overrun Clutch Valve Body
Shift Valve Body
Reverse Blocker Assembly
Manual Valve Body
Pressure Regulator
Torus Check Valve in Driven Torus
PAGE
77
82
84
87
87
88
89
90
91
91
91
91