1956 AMC Hudson Technical Service Manual Supplement

70 TECHNICAL SERVICE MANUAL
FIGURE 47—Removing Front Pump
Locking Screw
Remove the three 9/16" front pump attaching screws.
Then remove two opposite front pump cover to body screws
using 1/2" socket.
Install two slide hammers (J-6125) into the two opposite
cover to body screw holes in front pump, and remove front
pump assembly from case (Fig. 48).
NOTE: Front sprag inner race may stick in pump.
Be careful not to drop it on floor if it is in pump as
removed. Remove front sprag inner race if it did not
come out with pump.
1. Overrun Clutch Plate 3. Thrust Washer
2. Release Spring
FIGURE 49—Removing Overrun Clutch Thrust
Washer, Spring, and Plate
1. Special Tool J-6135
FIGURE 50—Case Support Holding Tool in
Position
CASE SUPPORT, NEUTRAL CLUTCH,
AND REAR UNIT ASSEMBLY REMOVAL
FIGURE 48—Removing Front Pump
Remove overrun clutch thrush washer, release spring,
and overrun clutch plate (Fig. 49).
Install case support holding tool J-6135, set screw end
toward front and lock securely (Fig. 50).
Remove speedometer driven gear from rear extension housing.
If rear oil seal is to be replaced, remove seal using tool
J-2623 and slide hammer J-2619B.
Remove rear extension housing and gasket and discard
gasket. It may be necessary to tap housing to rear to loosen.