1956 AMC Hudson Technical Service Manual Supplement
1956 AMC Hudson Technical Service Manual Supplement
1956 AMC Hudson Technical Service Manual Supplement
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
HYDRA-MATIC TRANSMISSION 93<br />
Install snap ring to retain seal and washer as shown in Figure<br />
59.<br />
INSTALLATION OF LOW BAND<br />
Install low band through front end of transmission case with the<br />
band ends facing rearward in a horizontal position (anchor support<br />
hole should face right hand side, Fig. 124).<br />
FIGURE 124—Installing Low Band<br />
When band is approximately half-way through transmission<br />
case, with band still horizontal, rotate band so that ends are in<br />
cavity in case above anchor pin and rotate band into position until<br />
anchor support hole in band fits on pin.<br />
1. Parking Pawl<br />
2. Parking Brake Lever<br />
3. Parking Brake Bracket<br />
4. Spring<br />
5. Inside Throttle Control Lever<br />
6. Spacer Washer<br />
7. Inside Detent Control Lever<br />
FIGURE 123—Parking Brake Lever Assembly<br />
INSTALLATION OF INSIDE DETENT<br />
AND THROTTLE LEVERS<br />
With throttle and detent levers assembled, place spacer washer<br />
over detent shaft against detent lever.<br />
Insert lever and shaft assembly through hole in case from<br />
inside with parking brake tang below pin in parking brake bracket.<br />
Install "0" seal and special washer which fits into bore of case<br />
over detent lever shaft.<br />
INSTALLATION OF REAR UNIT,<br />
NEUTRAL CLUTCH, AND<br />
CASE SUPPORT<br />
Install neutral clutch key in case using petrolatum to hold it in<br />
place. Position rounded side toward front to provide lead for<br />
guiding neutral clutch drum over key (Fig. 125).<br />
Position case support lock bolt hole with center of clutch plate<br />
drive lugs and mark rear drum with a pencil so that machined slot<br />
in neutral clutch drum can be guided into case to align with key<br />
and case support lock bolt (Fig. 126).<br />
Install assembly into case aligning pencil marks with neutral<br />
clutch key and push complete assembly into case and install large<br />
snap ring. If case support fits tight into case, it may be necessary<br />
to tap into place (Fig. 12.7).<br />
Install case support lock bolt and torque 25-30 ft. lbs.<br />
INSTALLATION OF REVERSE<br />
ASSEMBLY AND REAR PUMP<br />
Install reverse planet carrier on the output shaft aligning splines
Change language