1956 AMC Hudson Technical Service Manual Supplement

100 TECHNICAL SERVICE MANUAL
the center of the pin on the T.V. lever. Bend lever to conform
to this measurement (Fig. 144).
move the rod from the bracket and turn the adjusting end of
the T.V. rod to the left one lull turn; this lengthens the rod.
Replace and fasten the T.V. rod to the carburetor throttle rod
bracket. Tighten the hexagon nut to secure the adjusting end
of the T.V. rod (Fig. 145).
SELECTOR LEVER LINKAGE
ADJUSTMENT
FIGURE 144—T.V. Lever Measurement
With the carburetor set off of fast idle, adjust the upper T.V.
rod at the carburetor throttle rod bracket to engage the hole in
the bracket freely. Then remove
Place selector lever in the D-3 position and set the operating
lever against the stop on the starter switch bracket.
Remove clevis pin from the gear shift control rod at side of
transmission case and remove clevis from shift lever.
Place the transmission outer shift lever in the D-3 range position.
Adjust clevis so that clevis pin passes freely through hole in
lever with the operating lever against the stop on the starter
switch bracket. Then remove clevis and lengthen the control
rod two full turns and replace clevis and clevis pin.
NOTE: This adjustment will insure proper detent
location in the transmission with a full reverse engagement.
1. Upper T.V. Rod 2. Bellcrank 3. Lower T.V. Rod 4. T.V. lever
FIGURE 145—T.V. Linkage