QUICK & CRASH - The International Arcade Museum
QUICK & CRASH - The International Arcade Museum
QUICK & CRASH - The International Arcade Museum
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
6-6 Adjusting the Flat Target (U)/(L) Solenoids<br />
<strong>The</strong> Flat Target (U)/(L) Solenoid must be adjusted after replacement.<br />
1. Loosen the 4off socket flange head screws (M5x8), only sufficiently so that the<br />
solenoid can just be moved by hand.<br />
If the screws are loosened too much it will make it difficult to adjust the solenoid.<br />
2. Move and hold the solenoid plunger in the direction of arrow (a). Move the Flat<br />
target (U)/(L) solenoid in the direction of arrow (b) so that there is a gap of<br />
approximately 0.5mm between the flat target (U)/(L) solenoid and the solenoid<br />
plunger.<br />
Take care not to over stretch the solenoid spring.<br />
Adjust so that the gap between<br />
the Flat Target solenoid<br />
and the solenoid plunger<br />
is approx. 0.5mm<br />
Flat target solenioid<br />
b<br />
a<br />
Solenoid plunger<br />
Solenoid spring<br />
Flange socket head<br />
screws (M5x8)<br />
3. Re-tighten the 4off flange socket head screws (M5x8).<br />
After re-tightening the 4off flange socket head screws (M5x8) check that the<br />
gap between the Flat Target (U)/(L) solenoid and solenoid plunger is still<br />
approx. 0.5mm, if not repeat steps 1 to 3 above.<br />
Make sure that the main arm<br />
comes in contact with the<br />
rubber stopper D<br />
Main arm<br />
Solenoid plunger<br />
Flat target (U)/(L) position<br />
detector sensor<br />
Flat target (U)/(L) solenoid<br />
Rubber stopper D<br />
Stopper D<br />
Firmly press the solenoid plunger in the direction of the arrow, and make sure<br />
that the main arm comes in contact the Rubber Stopper D when the solenoid<br />
plunger comes in contact with the Flat Target (U)/(L) solenoid.<br />
Page 45