QUICK & CRASH - The International Arcade Museum
QUICK & CRASH - The International Arcade Museum
QUICK & CRASH - The International Arcade Museum
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
6. Replace the motor and reassemble in reverse order.<br />
Note: <strong>The</strong> shaft of the flat target motor has been ground flat in two places. When<br />
replacing the pulley ensure that the two double point screws are in contact with<br />
these flat faces.<br />
Flat Section<br />
Flat Target<br />
Motor Shaft<br />
Double Point<br />
(M5x6)<br />
Pulley<br />
Flat Section<br />
Before tightening the double point screws ensure that the gap between the top<br />
surface of the motor bracket and the pulley is approximately 2mm.<br />
Double Points<br />
(M5x6)<br />
Pulley<br />
Motor Bracket<br />
2mm<br />
It is recommended that Loctite 242 (part No 95000004) is applied to the double<br />
point screws when refitting the pulley.<br />
Page 82
Change language