QUICK & CRASH - The International Arcade Museum
QUICK & CRASH - The International Arcade Museum
QUICK & CRASH - The International Arcade Museum
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
7-22 Replacing the Flat Target Sensor PC Board<br />
Note: PC Boards are susceptible to damage from static electricity. Anti static<br />
precautions should be taken when removing, handling and refitting the PC<br />
Board.<br />
1. Remove the Flat Target Assembly. (See Section 7-18 page 77).<br />
2. Disconnect connectors (J301) and (J302).<br />
Locking Supports<br />
Front<br />
Connector<br />
(J301)<br />
Connector<br />
(J302)<br />
Flat Target<br />
Sensor PC Board<br />
3. Using needle nosed pliers, squeeze the locking tabs of the locking supports, one<br />
at a time, to release the PC Board. Remove the Sensor PC Board.<br />
PC Board<br />
Tab<br />
Locking Support<br />
Stopper<br />
Needle Nosed<br />
Pliers<br />
4. Replace the board by gently pushing the board on to the locking supports.<br />
Note: When replacing the Sensor Pc Board, ensure that connector (J301) is located at<br />
the front.<br />
Page 83