Inogen One G3 Technical Manual

Figure 2: Location of screws
3. Slide the front housing down and away from the device then lift up to remove.
Instructions for Removing the Column Receptacle:
1. With the device still on its back side, unscrew the two tube bracket screws (Figure 3) and
remove the tube bracket and set aside.
2. Disconnect the manifold tube corresponding to the receptacle being removed. Do this by
pressing down on the retaining ring while pulling gently on the tubing.
Manifold tubing
Figure 3: Tube bracket screws
3. In order to remove the receptacle, the corresponding column must be removed. Locate
the column latch on the underside of the device (Figure 4) and push downward on it
while simultaneously pulling the column out of the chassis. Remove the column and set
aside.
96-03997-00-01 revA Service Manual, Inogen One G3
- 140 -