Inogen One G3 Technical Manual

5. Plug in the compressor cable (Figure 8). Double check that the cable housing is locked
into the receptacle.
6. Place the black exhaust tube back through the compressor cable loop (Figure 8).
7. With all cables and tubing reattached, make sure all tubes are properly oriented in their
respected positions on the chassis before reinstalling the tube bracket. Reinstall the two
screws (Figure 3). Tighten screws to 6 in-lbs.
Instructions for Replacing the Housing:
1. Seat the feet of the front housing into the corresponding grooves on the chassis (Figure
11) then push down and toward the device to secure the housing in the chassis.
Figure 11: Housing feet and corresponding chassis grooves
2. Replace the two screws that connect the front housing to the chassis (Figure 2). Tighten
screws to 6 in-lbs.
3. Return the concentrator to the upright position
4. Slide the battery back into the chassis. Ensure the battery clip is fully seated
96-03997-00-01 revA Service Manual, Inogen One G3
- 52 -