Super Smart Ball Bushing Bearing - Hollin Applications

RoundwayRoundWay Linear Roller Bearingsfor Continuously Supported ApplicationsPhone: 1-800-554-8466Website: www.thomsonballbushing.comRoundWay* Linear Roller Bearing Type (Type A,B,C)• Available in 1 ⁄2 through 3 inch • Can be mounted in a customdiameters.housing.• Load capacity range between 970 • Available with a two piece seal thatand 24,000 lb f .retains lubrication while protecting• Travel speeds up to 100 ft/s.the bearing from the ingress of dirt• Accelerations up to 450 ft/s 2 .or contaminants.• Can be adjusted to compensate forvariations in the mounting surface.• Self-aligning in all directions.• Designed to compensate for two60 Case LinearRace ways that areslightly out of parallelRoundWay Linear Roller Bearing (Single Type)• Available in 1 ⁄2 through 3 inch • Should always be used in conjunctionwith RoundWay Dual version.diameters.• Load capacity range between 970 • Can be mounted in a customand 24,000 lb f .housing.• Travel speeds up to 100 ft/s. • Available with a two piece seal that• Accelerations up to 450 ft/s 2 .retains lubrication while protecting• Can be adjusted to compensate for the bearing from the ingress of dirtvariations in the mounting surface. or contaminants.• Self-aligning in all directions. • Easily mounted to carriage with four• Designed to compensate for two mounting bolts.60 Case LinearRace ways that areslightly out of parallelRoundWay Linear Roller Bearing (Dual Type)• Available in 1 ⁄2 through 3 inch • Available with a two piece seal thatdiameters.retains lubrication while protecting• Load capacity range between 1370 the bearing from the ingress of dirtand 35,000 lb f .or contaminants.• Travel speeds up to 100 ft/s. • Easily mounted to carriage with four• Accelerations up to 450 ft/s 2 .mounting bolts.• Can be adjusted to compensate forvariations in the mounting surface.• Self-aligning in all directions.Page 108©2003 Danaher Motion. Printed in the U.S.A. The specifications in this publication are believed to be accurate and reliable.However, it is the responsibility of the product user to determine the suitability of Thomson products for a specific application.While defective products will be replaced without charge if promptly returned, no liability is assumed beyond such replacement.* Trademark of Danaher Motion. DANAHER MOTION is registered in the U.S. Patent and Trademark Office and in other countries.