Super Smart Ball Bushing Bearing - Hollin Applications

Phone: 1-800-554-8466Website: www.thomsonballbushing.com60 Case LinearRace Support Blocksfor End Supported ApplicationsPrecision Steel Ball Bushing BearingsType FSB Flanged LinearRace Support BlockADCEBGJA C FBType FSB Flanged 60 Case* LinearRace* End Support BlocksA B C D E FPartNo.NominalLinearRaceDiameterd1.000(Dimensions in inches)G J±.010Hole BoltFSB-16 2.75 1.38 2.125 1.25 .63 1.50 .27 1 ⁄4 .31FSB-20 1.250 3.13 1.56 2.375 1.38 .75 1.75 .27 .38Masslb.801 ⁄4 .90Material: Aluminum AlloyDie Set DS (Dimensions in inches)NMPart NumberDS-16furnished with 2 clamps#CL-1 and 2 sockethead screws 1/4-20 x 1DS-20furnished with 3 clamps#CL-1 and 3 sockethead screws 1/4-20 x 1DS-24furnished with 3 clamps#CL-2 and 3 sockethead screws 5/16-18 x 1DS-32furnished with 4 clamps#CL-2 and 4 sockethead screws 5/16-18 x 1DS BallBushingBearingDS-16DS-20DS-24DS-32DS-B BallBushingBearingDS-16BDS-20BDS-24BDS-32BM1.061.271.561.94N1.411.612.002.38PRECISION(1)The Dynamic Load Capacity is based on a rated travel life of 2 million inches.The actual Dynamic Load Capacity can be affected by the orientation of the bearing or the direction of the applied load. For dynamic loadcorrection factors see polar graphs below.Note: For additional technical data, see Engineering Support Appendix.Polar GraphsThe actual Dynamic Load Capacity of a Ball Bushing bearing is determined by the orientation of the bearing or direction of the applied load. The load CorrectionFactor K 0 is found by knowing the direction of the applied load relative to the orientation of the bearings ball tracks and referring to the polar graph. To determinethe actual Dynamic Load Capacity, multiply the proper correction factor by the Dynamic Load Capacity listed in the product table on the previous page.K 0 K 0DS-16DS-20DS-24DS-32©2003 Danaher Motion. Printed in the U.S.A. The specifications in this publication are believed to be accurate and reliable.However, it is the responsibility of the product user to determine the suitability of Thomson products for a specific application.While defective products will be replaced without charge if promptly returned, no liability is assumed beyond such replacement.Page 85* Trademark of Danaher Motion. DANAHER MOTION is registered in the U.S. Patent and Trademark Office and in other countries.