NLS-HR100 Series Hand-held 1D Barcode Scanner User ... - Sensis

General ProgrammingReading ModeCommand Triggered ModeToolsCode Programming ONAfter programming, when the engine receives trigger sweep command fromterminal(e.g. PC)or read "Start Analog Trigger" barcode, the engine will start towork.Code Programming OFFPS: If reading is successful, data will be returned and the engine wil stop workingautomatically. Or the engine will keep reading until receiving stop command orreading "Stop Analog Trigger”.When the engine receives stop command from terminal (e.g. PC)or read "StopAnalog Trigger” barcode, the engine will stop. Meanwhile a 2 byte data(e.g.0A;0X) must be returned.Command Triggered Mode【Pro CMD:99900116】Start Analog Trigger【Pro CMD:99900035】StopAnalog Trigger【Pro CMD:99900036】If a reading is failed, the engine will send a character which means a reading failure. Users could set thecharacter themselves.Set Reading Failure Character【Pro CMD:99904200】nlscan.comPage 29