NLS-HR100 Series Hand-held 1D Barcode Scanner User ... - Sensis

SymbolsStandard 25Check DigitToolsCode Programming ONStandard 25 may include Check Digit (not compulsory) following itsbarcode messages. If included, it may be the last digit. It verifies the barcodemessage.» “NO Check, Transmit All” means to read without check and transmitall bytes including barcode message and Check Digit.» “Check, Do Not Transmit Check Digit” means to read and check.If verification is successful, transmits barcode message; if not, engine sendsan error beep.» “Check, Transmit All” means to read and check. If verification issuccessful, transmits all messages; if not, engine sends an error beep.Code Programming OFFNO Check, Transmit All【Pro CMD:99912203】Check, Transmit All【Pro CMD:99912204】Check, Do Not Transmit Check Digit【Pro CMD:99912205】When “Check, Do Not Transmit Check Digit” is enabled and barcode message lengthminus one is less than Min Message Length, it will lead to error beep.E.g.:Reading a 4-byte (include Check Digit) Standard 25 with the Min Message Lengthbeing 4 bytes and “Check, Do Not Transmit Check Digit” enabled leads to error beep.nlscan.comPage 91