NLS-HR100 Series Hand-held 1D Barcode Scanner User ... - Sensis

SymbolsCode 128Select Message LengthIt is used to program the valid reading length of Code 128. The engine willsend an error beep, if the decoded data length does not match the validlength.ToolsCode Programming ONCode Programming OFFCode 128 Message Length is defined by “Min. Message Length” and“Max. Message Length”.Min Message Length【Pro CMD:99910003】Max Message Length【Pro CMD:99910004】1D bar code Message Length should not exceed 255 bytes. If Max Message Length isless than Min Message Length, it means the engine will only support barcodes of the twolengths. If Max Message Length is equal to Min Message Length, the engine will only supportbarcodes of the length.To set Min Message Length of Code 128 to 8 bytes and Max Message Length to 12 bytes,read these programming codes1、“Code Programming ON”2、“Select Min Message Length”3、Digit Code “8”, see Digit Code4、“Save Programming”, see Digit Code5、“Select Max Message Length”6、Digit Code “1”7、Digit Code “2”8、“Save Programming”9、“Code Programming OFF”nlscan.comPage 53