NLS-HR100 Series Hand-held 1D Barcode Scanner User ... - Sensis

SymbolsCOOP25(Japanese Matrix 2 of 5)Select Message LengthToolsCode Programming ONIt is used to program the valid reading length of COOP25. The engine willsend an error beep, if the decoded data length does not match the valid length.Code Programming OFFCOOP25 Message Length is defined by “Min. Message Length” and“Max. Message Length ”.Min Message Length【Pro CMD:99911706】Max Message Length【Pro CMD:99911707】1D bar code Message Length should not exceed 255 bytes. If Max Message Length is lessthan Min Message Length, it means the engine will only support barcodes of the two lengths.If Max Message Length is equal to Min Message Length, the engine will only support barcodesof the length.To set Min Message Length of COOP25 to 8 bytes and the Max Message Length to 12bytes. Read these programming code:1. “Code Programming ON”2. “Select Min Message Length”3. Digit Code “8”, see Digit Code (Appendix Pxxx)4. “Save Programming”, see Digit Code (Appendix Pxxx)5. “Select Max Message Length”6. Digit Code “1”7. Digit Code “2”8. “Save Programming”9. “Code Programming OFF”nlscan.comPage 83