BROCADE IP PRIMER

Chapter 10: Routing Basics8. What is the administrative distance for a static route?a. 0b. 110c. 1d. 1209. What will RIPv1 advertise 172.16.3.0/24 as?a. 172.16.0.0b. 172.16.3.0/24c. 172.0.0.0d. 128.0.0.010. In RIP, how many hop counts are considered unreachable?a. 15b. 16c. 256d. 0Answers to Review Questions1. b. The route-only command is used at either the global or the interfacelevel to disable Layer 2 functions.2. d. The default administrative distance for RIP is 120.3. a. We would have also accepted ip route 0.0.0.0/0 10.1.1.14. d. Poison reverse is enabled by default. If it is disabled, split horizon willbe enabled.5. b. show ip route is correct.6. c. router rip in the Global config will enable RIP. You then need to specifyinterfaces that will participate.7. b. Nasty question. You don't configure a connected route, per se. It is createdwhen you assign an IP address to an interface.8. c. The default administrative distance for a static route is 1.9. a. RIPv1 is Classful. The first octet of the address is 172. This falls in theClass B realm. Class B's default subnet mask is /16, or 255.255.0.0. Thisincludes the first two octets for the network address, but assumes thelast two octets are for hosts.10. b. RIP can only count up to 15 hops. A route that is advertised as 16 hopsis considered unreachable.238 Brocade IP Primer