BROCADE IP PRIMER

Chapter 17: Firewall Load Balancing (FWLB)7. What is the maximum number of paths that can be supported?a. 2b. 36c. 32d. 168. Assuming Stateful FWLB is enabled on all my FWLB ServerIrons (in bothdirections), what command would I use to direct all SSL traffic to FW1?a. SLB-ServerIron(config-rs-FW1)#port sslb. SLB-ServerIron(config-rs)#ip policy 1 sslc. SLB-ServerIron(config-rs-FW1)#filter-match ssld. SLB-ServerIron(config)#port ssl9. What command would I use to define a firewall in the ServerIron's config?a. server real FW1 1.2.3.4b. server fw-name FW1 1.2.3.4c. server fwall-info FW1 1.2.3.4d. server firewall FW1 1.2.3.410. What command is used to prevent the firewall from being overwhelmed?a. limit connectionsb. max-tcp-conn-ratec. max-connd. max-rateAnswers to Review Questions1. b. The simplest configuration for FWLB (Basic) requires one ServerIron onthe outside of the firewalls, and one ServerIron on the inside of thefirewalls.2. c. TCS and FWLB dip from the same resource pool of four groups. If FWLBis enabled, that's one less that TCS can use.3. b. Firewall Group 2 is the only group configurable on any ServerIron.4. d. 16 firewalls can be load balanced with chassis ServerIrons.5. d. For IronClad, you need at least two ServerIrons on the outside of thefirewalls, and at least two ServerIrons on the inside of the firewalls.6. d. The firewall path describes the path that the ServerIron must take toreach the ServerIron on the opposite side of the firewalls.7. c. 32 paths are cuurently supported.384 Brocade IP Primer