BROCADE IP PRIMER

NetScreen – 204POWERSTATUS-1ALARMHASE SIONFLASHCONSOLE MODEM COMPACT FLASH 1TX / RX LINK10/1002TX /RX LINK10/1003TX /RX LINK10/100ServerIron4TX /RX LINK10/100ServerIronBI4XGBI24CT X RX T X RX T X RX T X RXBI4XGBI24CT X RX T X RX T X RX T X RXBI24C6 12 18 2430 36 42 48BI24CBigIron RX-8NETWORKS1 7 13 1925 31 37 43BI24CBI24CBI24CBI24CT X RX T X RX T X RX T X RXT X RX T X RX T X RX T X RXAC OK DC OK ALMEJECT SYS AC OK DC OK ALMEJECT SYS AC OK DC OK ALMEJECT SYS AC OK DC OK ALMBI4XGBI4XGNetScreen – 204EJECT SYSPOWERALARMSTATUS-1SE SIONHAFLASHCONSOLE MODEM COMPACT FLASH 1TX / RX LINK10/1002TX /RX LINK10/100BI4XGBI24CT X RX T X RX T X RX T X RXBI4XGBI24CT X RX T X RX T X RX T X RXBI24C6 12 18 2430 36 42 48BI24CBigIron RX-8NETWORKS1 7 13 1925 31 37 43BI24CBI24CBI24CBI24C3TX /RX LINK10/100ServerIron4TX /RX LINK10/100ServerIronT X RX T X RX T X RX T X RXT X RX T X RX T X RX T X RXAC OK DC OK ALMEJECT SYS AC OK DC OK ALMEJECT SYS AC OK DC OK ALMEJECT SYS AC OK DC OK ALMBI4XGBI4XGEJECT SYSNetScreen – 204POWERALARMSTATUS-1SE SIONHAFLASHCONSOLE MODEM COMPACT FLASH 1TX / RX LINK10/1002TX /RX LINK10/1003TX /RX LINK10/1004TX /RX LINK10/100Configuring FWLBIronClad FWLBINTERNETFirewallFirewallFirewallConfiguring FWLBIn either the basic or the IronClad solution, you need at least one ServerIronoutside the firewall (to load balance incoming traffic), and at least oneServerIron inside the firewall (to load balance outgoing traffic). When configuringIronClad, you configure a pair of ServerIrons outside the firewall, and a pairof ServerIrons on the inside. The pairs must be either both chassis models orboth stackables. The ServerIron FWLB solution currently supports a maximumof 16 firewalls.IronClad can be configured as either active/standby or active/active.To configure FWLB, you go through six steps:1. Define the Firewall Servers2. Define the Firewall Group3. Assign the Firewall Servers to the Firewall Group4. Configure the Firewall Paths5. Enable FWLB6. Configure Static MAC entries (optional, dependent on configuration)You need to perform these steps on both the Outside ServerIron(s), and theInside ServerIron(s).Brocade IP Primer 375