Alternative Construction Research Guide - GCCDS

More documents

Recommendations

Info

Chapter 5, Elevated Foundations, is currently undergoingrevisions and will be reuploaded to the webpage and thedocument .pdf shortly. Please check back soon for updates.
Flooring SystemsResidential floors are typically an assembly ofstructural floor joists, overlaid with a subfloorsheathing and covered by any of a wide rangeof finish materials. <strong>Alternative</strong>ly, floors canbe constructed of a material that acts as bothstructural subfloor and finished floor. Materialssuch as concrete (both cast-in-place and pre-castpanels) and tongue & groove dimensional lumbercan be used in this way.Floor FinishesAmong the many floor finishes available areengineered (laminate) wood, bamboo, cork,vinyl, rubber, linoleum, natural- or syntheticfibercarpet, tile, and stone. The choice of finishmaterial will depend on many factors. Comfortand appearance are high priorities in the livingareas of the house. Durability and ease ofmaintenance are important in high-use roomsand especially in wet rooms such as kitchens andbathrooms. Affordability and ease of installationare factors that vary greatly among floor finishes.Finally, the impact on the environment andthe indoor air quality of the house should beconsidered.Environmentally Preferable ProductsA variety of environmentally preferable flooringproducts are available. Some, such as bamboo,cork, and other woods, are produced from fastgrowing,renewable sources. Others, such ascarpeting and tile, can include recycled content.Products that contain rubber, formaldehyde,harmful sealants, or other materials that offgasshould be avoided or used only in wellventilatedareas. Linoleum, which uses morerenewable materials and off-gasses less, is anenvironmentally preferable alternative to vinyl.Carpeting should be avoided, as it collects dirtand mold, especially in moist climates, andadhesives and backers can off-gas; area rugs are aenvironmentally preferable choice.(FIG.A) TONGUE AND GROOVE FLOORING This2x6 southern yellow pine floor will be sanded andfinished with a stain or sealer.(FIG.B) FINISH MATERIALS are applied on topof the subfloor. In the past decade more sustainablefinish materials have become widely available.(FIG.C) SUSPENDED CAST-IN-PLACE DECKS canbe used in combination with ICF walls and a concretefoundation system.small component systems Flooring Systems
Page 3:
The Gulf Coast Community Design Stu
Page 10:
factoryassembledhomesconstructionpr
Page 13 and 14:
Required Equipment: A crane and lif
Page 15 and 16:
Component Homes | 1.2Component Home
Page 17 and 18:
DESIGNComponent Homes | 1.2Environm
Page 19 and 20:
PERFORMANCEWind Load: Kits can be d
Page 21: stall whatever the factory assemble
Page 24 and 25: panelsconstructionprocessspeeddeliv
Page 26 and 27: 2.1 | Wood SIPsWood SIPsOverview: S
Page 28 and 29: 2.1 | Wood SIPsLife Span: The OSB a
Page 30 and 31: 2.1 | Wood SIPsMM & I Construction
Page 32 and 33: 2.2 | Non-Wood SIPsand full constru
Page 34 and 35: 2.2 | Non-Wood SIPssome information
Page 36: 2.3 | Framed PanelsThe strength of
Page 39 and 40: Stacked Unit SystemsStacked unit sy
Page 41 and 42: 3STACKED UNIT SYSTEMSsubjects3.1 In
Page 43 and 44: should be done carefully, as the co
Page 45 and 46: Concrete Masonry Units (CMU) | 3.2C
Page 47 and 48: Concrete Masonry Units (CMU) | 3.2D
Page 49 and 50: AAC is naturally resistant to termi
Page 51 and 52: Framing SystemsFraming systems are
Page 53 and 54: 4FRAMING SYSTEMSsubjects4.1 Convent
Page 55 and 56: which allows for expedient construc
Page 57 and 58: Advanced Wood Framing | 4.2Advanced
Page 59 and 60: esidential building codes but may n
Page 61 and 62: ut can be designed to carry increas
Page 63 and 64: Water Resistance: Steel studs are t
Page 65 and 66: Engineered Floor Trusses | 4.5Engin
Page 67 and 68: Versatility / Flexibility: Engineer
Page 69 and 70: equired, construction crews should
Page 74 and 75: floorsconstructionprocessspeeddeliv
Page 76 and 77: 6.1 | 2x6 Tongue and Groove Decking
Page 78 and 79: 6.2 | Suspended Cast-in-Place Decks
Page 80 and 81: 6.2 | Suspended Cast-in-Place Decks
Page 82 and 83: 6.3 | Floor FinishesSpeed of Constr
Page 84 and 85: 6.3 | Floor FinishesGULF COAST AVAI
Page 86 and 87: insulationrequiredequipmentthermalp
Page 88 and 89: 7.1 | Exterior FinishesExterior Fin
Page 90 and 91: 7.1 | Exterior FinishesEnergy / The
Page 92 and 93: 7 .2 | SheathingSheathingOverview:
Page 94 and 95: 7 .2 | SheathingMarket Exposure: OS
Page 96 and 97: 7.3 | InsulationAfter the foam drie
Page 98 and 99: 7.3 | InsulationInstallation: Miner
Page 100 and 101: 7.4 | Interior Finishesthe job and
Page 102 and 103: 7.4 | Interior FinishesWOOD & WOOD
Page 104 and 105: 7.4 | Interior FinishesMASONRYStone
Page 106 and 107: oofsconstructionprocessspeeddeliver
Page 108 and 109: 8.1 | Radiant BarriersRoofRadiant b
Page 110 and 111: 8.1 | Radiant Barrierssometimes rea
Page 112 and 113: 8.2 | ShinglesEnergy/Thermal: Aspha
Page 114 and 115: 8.3 | Metal RoofsBecause the screws
Page 116 and 117: 8.4 | Tile RoofsPERFORMANCETile Roo
Page 118 and 119: 8.5 | Rubber RoofsINSTALLATIONRubbe
Page 120 and 121: 8.5 | Rubber RoofsDESIGNEnvironment
Page 122 and 123:
App. I | Insuring HomesI. Insuring
Page 124 and 125:
App. II | Energy Efficiency in Home
Page 126 and 127:
App. II | Energy Efficiency in Home
Page 128 and 129:
App. III | Site WorkIII. Site WorkT
Page 130 and 131:
App. IV | Further ResearchIV. Furth
Page 132 and 133:
App. V | GlossaryCompression: Physi
Page 134 and 135:
App. V | GlossaryShear Wall: Walls
Page 136 and 137:
App. VI | EndnotesChapter 3: Cast a
Page 138 and 139:
App. VI | Endnotes2. “HardiePlank
Page 140 and 141:
App. VII | Images UsedFig.8Fig.9Fig
Page 142 and 143:
App. VII | Images UsedFig.16Fig.17I
Page 144 and 145:
App. VII | Images UsedFig.2Fig.3Fig
show all

Alternative Construction Research Guide - GCCDS

Create successful ePaper yourself

Delete template?

Save as template?