Flight and Operation Manual Rev 3.0 on 09-04-2013 - Trixy Aviation

All hub bolts are in place No deformation or surface damage Check wear of the rotor-brake padRotorhead Check pre-rotator gears for wear Check main bearing for ease of motion Bendix-gear axes lubricated <strong>and</strong> free rotatable Check safety splint pins for proper seatingRotor control rod Check push rods for proper attachment <strong>and</strong> wear Check bell crank for ease of motion <strong>and</strong> wear Control stick (also in back if available) is freely movable <strong>and</strong> hasno play in all directionsRudder Check pedals <strong>and</strong> cables for free movement <strong>and</strong> cables forabrasions Rudder <strong>and</strong> stabilizers properly mounted <strong>and</strong> not damaged Check end stops with relieved nose wheel Rudder hinges secure <strong>and</strong> without playFrame Check all frame parts for deformations or cracks Check seat shell <strong>and</strong> holding fixture for proper seatingUndercarriage Check tire pressures <strong>and</strong> condition Check mounts <strong>and</strong> proper seating of main undercarriageNose wheel Lift nose wheel <strong>and</strong> check for freedom of movement Check welds, linkage <strong>and</strong> wheel fork for proper seatingWheel brakes Check for function Check brake fluid level Check wear of brake pads<strong>Flight</strong> <strong>and</strong> operation manual G 4-2 <strong>Rev</strong>ision <strong>3.0</strong> – 09.04.2013 29