Installation Operation and Maintenance Manual

Maintenance (Continued)134236A370D496253B4235. Remove the bearing housing O-ring (496).6. Remove the clamp ring screws (236A) and separate the clamp ring (253B) from the bearing housing(134).You must remove the bearings before you can remove the clamp ring from the shaft.7. Remove the bearing housing (134) and the bearings (112A and 168A) from the shaft (122).250355370H1848. Remove the inboard bearing (168A).122168A382136253B112A9. Remove the bearing locknut (136) and bearing lockwasher (382).10. Remove the outboard bearings (112A).NOTICE: Use force only on the inner race when you press bearings off the shaft. Do not use forcein situations in which you might break a part. Doing so may result in equipment damage.NOTICE:Save the bearings for inspection. Do not reuse the bearings. Doing so may result in decreasedperformance.78 Model 3796 i-FRAME Installation, Operation, and Maintenance Manual