testing
This is just a test
This is just a test
- No tags were found...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
MS-7589<br />
▶Current CH1/ CH2 tdrRdTRd/ tddRdTRd/ tsrRdTWr/ tdrRdTWr/ tddRdTWr/<br />
tsrWrTRd/ tddWrTWr/ tsrRDTRd/ tsrWrTWr<br />
These item show the advanced DRAM timings.<br />
▶Channel 1/ Channel2 Advanced Memory Setting<br />
Setting to [Auto] enables the advance memory timing automatically to be determined<br />
by BIOS. Setting to [Manual] allows you to set the following advanced memory timings.<br />
▶Memory Ratio<br />
This item allows you to set the memory multiplier.<br />
▶Adjusted DRAM Frequency (MHz)<br />
It shows the adjusted DRAM frequency. Read-only.<br />
▶QPI Ratio<br />
This item allows you to set the QPI multiplier.<br />
▶Adjusted QPI Frequency (MHz)<br />
It shows the adjusted QPI frequency. Read-only.<br />
▶ClockGen Tuner<br />
Press to enter the sub-menu and the following screen appears.<br />
▶CPU Amplitude Control/ PCI Express Amplitude Control<br />
These items are used to select the CPU/ PCI Express clock amplitude.<br />
▶Adjust PCI-E Frequency (MHz)<br />
This field allows you to select the PCIE frequency (in MHz).<br />
▶Auto Disable PCI Frequency<br />
When set to [Enabled], the system will remove (turn off) clocks from empty PCI slot to<br />
minimize the electromagnetic interference (EMI).<br />
▶CPU Voltage(V)/ PCH 1.8V (V)/ DRAM Voltage (V)/ DDR_VREF_CA_A (V)/ / DDR_<br />
VREF_CA_B (V)/ DDR_VREF_DA_A (V)/ / DDR_VREF_DA_B (V)/ PCH 1.05V (V)<br />
These items are used to adjust the voltage of CPU, Memory and chipset.<br />
▶Spread Spectrum<br />
When the mainboard’s clock generator pulses, the extreme values (spikes) of the pulses<br />
create EMI (Electromagnetic Interference). The Spread Spectrum function reduces the<br />
EMI generated by modulating the pulses so that the spikes of the pulses are reduced<br />
to flatter curves.<br />
Important<br />
• If you do not have any EMI problem, leave the setting at [Disabled] for optimal system<br />
stability and performance. But if you are plagued by EMI, select the value of Spread<br />
Spectrum for EMI reduction.<br />
3-23