BIG KAISER High Performance Tooling Solutions 2018-2019

SPEED FINISHER OVERVIEW
CUTTER DIAMETER: ø50, ø63, ø80, ø100, ø125, ø160
High Speed Cutter for Aluminum and Cast Iron
Greatly improves the surface finish in ultra-high-speed machining!
Achieves Rz = .55μm for die-cast aluminum ADC12 and Rz
= .67μm for gray cast iron FC250.
Insert
Lifting Screw
Lifting Nut
Speedily Adjusts the Cutting Edge Height
It has a simple and highly operable mechanism in which the cutting
edge height is adjusted after clamping the insert by turning the lifting
nut from the side, then directly pushing up the insert with the lifting
screw. Since the lifting screw has a fine pitch (.25mm), accurate
adjustment is possible.
Combines Light Weight and High Rigidity
The slim body allows increased rigidity and reduced vibration and deflection.
Therefore, height difference of the machined surface is minimized.
Also, as it is lighter than other cutters, it can be safely used with a small #30
taper machining center.
Slim Design
Competitor Product
Direct Coolant Supply to The Cutting Edge
Use in combination with the Face Mill Arbor Type FMH allows coolant to
be supplied directly to the cutting edge.
This prevents welding and re-cutting of chips in aluminum workpieces.
Not only has the finishing surface roughness been improved, but by correctly aligning the cutting edge height, feed per tooth can also be increased for the
same surface roughness, allowing high-efficiency machining. As the insert uniformly touches the workpiece, the life can also be extended.
50