Chapter 3. Operating NetView FTP V2.2.1 MVS - IBM

Example of Initialization Parameters for a Server
The following example shows sample initialization parameters for a server with LU
name FTP01.
LUNAME=FTP�1
DLOGMOD=FTBIND
BYTECR=5�K
GID=DVG,CLASS=(1,3,9)
Figure 62. Example of Initialization Parameters for a Server
If this server is the receiving part of a transfer, it periodically takes a checkpoint
after every 50KB have been received. If a name for a new receiving physical
sequential data set or PDS must be created, this server uses the string DVG as the
first qualifier. This server can process file-transfer requests with classes 9, 3,
and 1. The entry (MODEENT) in the module table (MODTAB) uses the name
FTPBIND.
Initialization Parameters for an OSI Server
The keywords for the initialization parameters for an OSI server are shown in
Figure 63.
Figure 63. OSI Server Initialization Parameters
Parameter Keyword Page
OSI Server Name OISVNAME 125
VTAM LU name of OSI/File Services OIFTAMID 125
VTAM LU Name for the Server OIAPPLID 125
Local User Name OIUSERID 125
Local User Password OIUSRPWD 126
New Local User Password OINUSRPW 126
Server Running Mode SRVMODE 125
Obtain Interval OBTINTVL 126
Limit the Maximum Number of Simultaneous
Requests
MAXSESS 126
Maximum Number of Active Transfer Requests AVLSESS 126
Maximum Number of Locally Initiated Requests AVLLRH 127
Maximum Number of Remotely Initiated
Requests
AVLRRH 127
Retry Delay Time RETRYDELAY 127
Recovery Delay Time OIRECDEL 127
Termination Time TTIME 128
Server Classes CLASS 128
Internal Trace TRACE 128
124 NetView FTP V2 MVS Installation, Operation, and Administration