Chapter 3. Operating NetView FTP V2.2.1 MVS - IBM

Error Situations in the Interactive Interface
There are situations, where the interactive interface cannot display a panel or a
message. In other situations, an error panel is displayed, but the user must circumvent
the error situation. In these cases a return code is displayed on the first line
of the panel, if you called the interactive interface with ISPF 7.1 (dialog test).
To call the interactive interface under dialog test, select option 1 (Function) from the
Dialog Test Primary Option Menu. Then invoke the Dialog Function/Selection
Menu using:
� PGM: DVGIFII
Figure 99. Errors Handled by Error Panels
� PARM: x (where x is your National Language Character).
Figure 99 explains the error situations and gives some hints on how to solve the
problem.
Error Panel Explanation Actions
DVGME9AE This panel is displayed only for partitioned data
set member selection.
The error situation can occur, if you send a partitioned
data set that does not already exist on
another location without specifying one or all
members. The interactive interface creates a
member list when you select SUBMIT from the
Current Task Selection panel (DVGME0Kx) or
from the List Saved Requests panel
(DVGME0Rx). You select or exclude which
members to transfer from this list. Since the
data set does not already exist, a member list
cannot be created and that error panel is displayed.
DVGME9CE This error occurs when a panel cannot be displayed.
One of the following may be true:
1. The panel or the message library is not allocated.
2. The specified panel does not exist in the
panel library.
3. A message should be displayed with the
panel. The message is not contained in the
message library.
4. The specified panel contains an error.
1. Check that you selected the correct data set
for transfer.
2. If it is correct (for example, an error may
have been indicated if the transfer is to start
at a later time after you have created the
data set), you cannot use the member
selection function. You have to transfer a
single member or the complete data set. In
both cases the member selection list is not
displayed.
3. Correct the request and submit it.
1. Check the allocated panel and message
libraries.
2. Check if the displayed panel exists in the
panel library.
3. Test the displayed error panel using ISPF
7.2 to find any errors in that panel.
DVGME9DE ISPF returned with an error code. 1. Panel DVGME9DE displays the information
you need to analyze the error: the last ISPF
command, the return code, and the short
and long error message.
2. Analyze the return code and the ISPF error
message by using the ISPF books.
DVGME9FE ISPF could not open the saved request table.
Possible explanations are:
� The ISPTABL or ISRTABL is not allocated
� The ISPTABL or ISRTABL is in error.
DVGME9GE This error occurs for a serious internal error.
The error panel shows the previous panel and
the next.
154 NetView FTP V2 MVS Installation, Operation, and Administration
Check your allocation and correct it.
Report these panel names to your IBM representative.