Chapter 3. Operating NetView FTP V2.2.1 MVS - IBM

Verifying the Access to the Interactive Interface Routine
The following steps verify the access to the interactive interface routine.
1. Ensure that the NetView FTP V2.2.1 MVS queue handler is running.
2. If the NetView FTP V2.2.1 MVS interactive interface has been allocated via the
TSO logon procedure or with a TSO startup CLIST, do the following:
� From a terminal that is in TSO READY mode, enter:
ISPSTART PGM(DVGIFII) PARM(E)
The letter you specify as a parameter is the language the panels are
written in. E indicates English.
If the NetView FTP V2.2.1 MVS interactive interface has been allocated via the
ISPF LIBDEF statement, call the DVGMXRII CLIST from the ISPF command
line.
NetView FTP V2.2.1 MVS displays the main NetView FTP V2.2.1 MVS
selection panel.
3. Enter PANELID on the command line. The panel ID shown in the upper left
corner of the screen must be DVGME00E.
4. Request help by either entering HELP or pressing the HELP PF key. The first
NetView FTP V2.2.1 MVS help panel is displayed. It shows the current maintenance
level of NetView FTP V2.2.1 MVS.
5. Return to the main selection panel.
This completes the access verification of the interactive interface.
Verifying the Installation of the OSI Part of NetView FTP V2.2.1 MVS
To perform the installation verification test of the OSI part of NetView FTP V2.2.1
MVS do the following:
1. Start the NetView FTP V2.2.1 MVS queue handler as described in “Starting the
Queue Handler” on page 28.
2. Make sure that OSI/File Services is active.
3. Start the NetView FTP V2.2.1 MVS OSI server.
Enter from the operator console:
F DVG230QH,S DVG230SI
4. Let the OSI server run for about ten minutes.
5. Stop the NetView FTP V2.2.1 MVS OSI server.
Enter from the operator console:
F DVG230QH,P DVG230SI
6. Allow three minutes for termination, then check that the DVG230SI address
spaces have terminated.
Chapter 2. Installing, Preparing, and Verifying the Installation of NetView FTP V2.2.1 MVS 39