Chapter 3. Operating NetView FTP V2.2.1 MVS - IBM

SUB=subsystem
The name of the subsystem that is to select the job for processing. The subsystem
specified must be active and must support job selection. The default
value is the primary job entry subsystem.
For more information see MVS/ESA Operations Systems Commands or
MVS/XA Operations Systems Commands.
keyword=option
Any appropriate keyword specified to override the corresponding parameter in
the cataloged procedure.
For more information see MVS/ESA Operations Systems Commands or
MVS/XA Operations Systems Commands.
Example: To start a server using a cataloged procedure named FTPSRV03,
enter the following:
START FTPSRV�3.SV�3
Using the MODIFY Command
You can use the MODIFY command to call a cataloged procedure to start a server.
The following command modifies the queue handler to start a server:
►►──┬─MODIFY ─┬──id──┬─,START
─┬──m────────────────────────────────►◄
└─F ──────┘
└─,S ─────┘
id The identifier that you used in the START command to start the queue handler.
m One of the following:
� A number (0 through 9 or 00 through 99) that is the suffix of the name of
the cataloged procedure of a server. These digits are added to the prefix
specified for the server in the initialization parameters for the queue
handler. Refer to SRVPREF described in “Specifying Values for the Queue
Handler Initialization Parameters” on page 99.
� A name of up to eight characters that is the complete name of the cataloged
procedure for the server. If a server is started using this method, it
must be stopped using the same name.
Examples:
MODIFY QH,START �3
F QH,START FTPSRV�3
Using a Batch Job
You can start a server by submitting a startup job. An example of a startup job is
the DVGSTSV member in DVG.NFTP230.INSTLIB.
48 NetView FTP V2 MVS Installation, Operation, and Administration