Chapter 3. Operating NetView FTP V2.2.1 MVS - IBM

Keyword (Value)
The event passes the following parameters:
JOBNAME (name of the job issuing the event)
UNIT (unit address of device in error)
DEVC (device type)
DA - direct access device
TA - magnetic tape device
UR - unit record device
DDNAME (DD name of data set)
OPER (operation attempted)
BLCK (device type dependent)
if DA - actual track address and block number in hexadecima l
if TA - relative block number in decimal
if UR - asterisks.
ACCESS (access method)
The values of the UNIT, DEVC, DDNAME, OPER, BLCK, and ACCESS keywords
are results of the SYNADAF error analysis macroinstruction.
VSAM Error
This event is issued if an error occurs in a VSAM data set. It can be in any of the
following:
� The request-queue of the queue handler
� The checkpoint data set of the server
� The sending or receiving data set.
Event_ID (Event_No)
VSAMER(2)
Keyword (Value)
The event passes the following parameters:
JOBNAME (name of the job issuing the event)
OPER (operation attempted)
RC (VSAM return code)
DDNAME (DD name of data set)
Abend During I/O
This event is issued if an abnormal termination occurs during an I/O operation.
Event_ID (Event_No)
IOABEND(3)
Keyword (Value)
The event passes the following parameters:
JOBNAME (name of the job issuing the event)
OPER (operation attempted)
LOCDSN (data set name)
SYSABCD (system abend code)
252 NetView FTP V2 MVS Installation, Operation, and Administration