Chapter 3. Operating NetView FTP V2.2.1 MVS - IBM

Verifying the Installation of NetView FTP V2.2.1 MVS
When you have completed the steps described in “Preparing the NetView FTP
V2.2.1 MVS Program” on page 19, follow the steps described here to verify that
NetView FTP V2.2.1 MVS is functioning correctly. If any of the sample jobs supplied
do not suit your system, you can modify them.
Preparing for the Installation Verification Test
The following list contains some prerequisites for the installation verification tests.
1. Ensure that the queue handler procedure DVG230QH is stored in a systemknown
procedure library, such as SYS1.PROCLIB.
2. Ensure that the server procedures DVG23001 and DVG23002 are stored in a
system-known procedure library, for example, SYS1.PROCLIB.
3. If your installation uses RACF, ensure that the queue handler procedure
DVG230QH and the server procedures DVG23001 and DVG23002 have been
authorized.
4. Activate the VTAM major node (sample DVGSVAPP) for the server LUs and
verify that the resource status of the LUs is connectable (CONCT).
5. The queue handler must be invoked as a started task using a cataloged procedure.
A sample procedure, DVG230QH, is contained in library
DVG.NFTP230.INSTLIB. If the contents of the sample procedure do not suit
your system, modify it and then submit it. How this is done is described in
“Procedure to Start the Queue Handler” on page 95.
6. The NetView FTP V2.2.1 MVS servers can be invoked as a started task or by a
batch job. If the contents of the sample procedure do not suit your system,
modify it and then submit it. In “Procedure to Start a Server” on page 105 is
described how to do this. In this verification test, the servers are invoked as
started task and started by the queue handler.
7. The sample server-group table DVGSVGRP is used during the installation verification
tests 1 and 2.
Starting the Queue Handler
To start the queue handler do the following:
1. Enter S DVG230QH.QH from the operator console. QH identifies the queue
handler to the system. This ID is used for further actions.
When the queue handler starts, it reads its initialization parameters from the file
DVGQHP in library DVG.NFTP230.PARMLIB.
2. Wait until the queue handler issues the ready message DVG402I.
If the queue handler stops before issuing the ready message, check the messages
issued to the DVGLOG. The messages are described in the NetView
FTP Messages and Codes manual. Correct any errors and start the queue
handler again.
28 NetView FTP V2 MVS Installation, Operation, and Administration