Chapter 3. Operating NetView FTP V2.2.1 MVS - IBM

Starting Servers
After you have successfully completed “Starting the Queue Handler” on page 28, at
least two NetView FTP V2.2.1 MVS servers must be active. Check the MVS
system console for these messages:
DVG�25I SERVER DVG23��1 READY
DVG�25I SERVER DVG23��2 READY
If only one or none of these messages appear, check the messages issued to
server log files. The messages are described in the NetView FTP Messages and
Codes manual. Correct any errors and restart the server by the appropriate start
command:
� Enter F QH,S DVG23001 to start server 1
� Enter F QH,S DVG23002 to start server 2.
Overview of the Installation Verification Tests
The following samples are created by the installation job generator and are located
in the library DVG.NFTP230.INSTLIB. In the samples, the values shown in bold
characters are generated by the installation generator. You can modify them to suit
your own installation. Values shown in lowercase must be replaced by values
appropriate for your installation.
For installation verification test 1 and 2, the queue handler, server 01, and server
02 must be active. For installation verification test 3, only the queue handler must
be ready.
The sample job DVGMVBFV creates a test data set. This data set is used for the
verification test 2.
For verification test 1 the following members are used:
DVGMVAD1 To add a file-transfer request
DVGMVQR1 To query a specific file-transfer request.
For verification test 2 the following members are used:
DVGMVAD2 To add a file-transfer request
DVGMVQR2 To query all file-transfer requests of this originator
DVGMVMY1 To release the request.
For verification test 3 the following member is used:
DVGMVADM To perform administrator queries.
Chapter 2. Installing, Preparing, and Verifying the Installation of NetView FTP V2.2.1 MVS 29