The Alchemy Key.pdf - Veritas File System

Appendix 3 King Solomon's Method
The following method is an edited summary of an anonymous
article entitled Simple Methods of Making Monatomic Gold. 1450 It has the
following disclaimers:
New information regarding monatomic elements has been made
available to this forum and the world. This information comes from a
scientist who wishes to remain anonymous. It is the wish of this scientist
that this information be made freely available and that his anonymity be
protected. His expertise is in the field of metallurgy and mining and he
holds degrees in five different physical sciences. He has been working
with the monatomic precious elements since 1980.
The author of this post does not claim that all of this information
is accurate or even that any of it is true. It may contain errors and be
incomplete in places.
Any unknown material should be subjected to a 98 element scan
prior to conversion to m-state material for ingestion.
King Solomon's Method
King Solomon’s people swept up the white material present when
a lake dries. They did not dig because they only wanted the material on
the surface. They fired this material with sulfur, put silver on top of it and
mixed in iron. Using this method and a reverberatory furnace, they
poured 100,000 talents of gold.
Both damp evaporated salts and water from the Dead Sea produce
a quantity of precipitate. Reconstituted Dead Sea salt water is far more
concentrated, produces a much greater amount of precipitate and requires
much more lye (dilute NaOH) to bring it up to the desired pH level.
The procedure for extracting monatomic elements from dry
material such as sweepings from salt and alkali flats, rock powders, etc. is
as follows:
1. Grind the dry material to as fine a consistency as possible.
2. Add lye to cover the dry material with a thin layer and stir in
distilled water sufficient to cover both by approximately 50mm.
3. Bring to boil outdoors where caustic fumes can escape. The
pH should be at or slightly above 12. Replace water as needed to
maintain sufficient reactant volume.
4. Maintain at boiling temperature for four hours, the longer the
better.
402