Program Policy Manual - VOLUME V - Mine Safety and Health ...
Program Policy Manual - VOLUME V - Mine Safety and Health ...
Program Policy Manual - VOLUME V - Mine Safety and Health ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
MSHA PROGRAM POLICY MANUAL <strong>VOLUME</strong> V<br />
inspector has reason to believe that any equipment, including<br />
off-track mining equipment, has been allowed to contact the<br />
trolley or trolley feeder wires, creating a short circuit, this<br />
Section should be cited.<br />
The following precautions are considered adequate for movement<br />
of equipment other than off-track mining equipment in track <strong>and</strong><br />
trolley entries:<br />
1. Maintenance of 12 inches vertical clearance between the<br />
equipment being moved <strong>and</strong> energized trolley or trolley<br />
feeder wires; or<br />
2. Deenergization of the trolley <strong>and</strong> trolley feeder wire<br />
while equipment is being moved along track <strong>and</strong> trolley<br />
entries; or<br />
3. Transportation of the equipment in a mine car or other<br />
vehicle having two sides with dimensions not greater<br />
than the sides of mine cars normally used in the track<br />
haulage system. The equipment being transported shall<br />
not extend above the sides of the mine car; or<br />
4. Transportation of small items of mine equipment, such as<br />
small pumps, component parts of mining equipment, <strong>and</strong><br />
mine supplies, in a vehicle that normally traverses the<br />
intended route, provided no part of the equipment being<br />
transported extends higher than that part of the frame<br />
of the vehicle that is in front of or to the rear of the<br />
item being transported.<br />
If items 1 through 4 cannot be met, adequate protection would<br />
require compliance with Sections 75.1003-2(a) through 75.1003-<br />
2(f)(5) or other equally effective safeguards designed to insure<br />
that such equipment will not contact energized trolley wires or<br />
trolley feeder wires.<br />
75.1003-2 Requirements for Movement of Off-Track Mining<br />
Equipment in Areas of Active Workings Where<br />
Energized Trolley Wires or Trolley Feeder<br />
Wires are Present; Premovement Requirements;<br />
Certified <strong>and</strong> Qualified Persons<br />
"Off-track mining equipment" for the purpose of this Section is<br />
interpreted to be a major item of complete or reasonably<br />
complete mining equipment, built on its own individual frame,<br />
consisting of its own components, performing its own unique<br />
function, <strong>and</strong> not designed to operate on mine track. "Off-track<br />
mining equipment" includes all self-propelled equipment<br />
February 2003 (Release V-33) 89