Program Policy Manual - VOLUME V - Mine Safety and Health ...
Program Policy Manual - VOLUME V - Mine Safety and Health ...
Program Policy Manual - VOLUME V - Mine Safety and Health ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
MSHA PROGRAM POLICY MANUAL <strong>VOLUME</strong> V<br />
citation can be issued. Nothing here is intended to eliminate<br />
the issuance of a 107(a) order when an imminent danger exists.<br />
75.1403-3 Criteria - Drum Clutch; Cage Construction<br />
At the bottom of each hoisting shaft <strong>and</strong> at intermediate l<strong>and</strong>ings,<br />
a "runaround" should be provided for safe passage from one side of<br />
the shaft to the other. This passageway should be not less than 5<br />
feet in height <strong>and</strong> 3 feet in width.<br />
Ice should not be permitted to accumulate excessively in any shaft<br />
where miners are hoisted or lowered.<br />
No person should ride a cage with equipment, supplies, or<br />
materials. This does not prohibit the carrying of small h<strong>and</strong>tools,<br />
surveying instruments, or technical devices.<br />
75.1403-5 Criteria - Belt Conveyors<br />
The requirements for the transportation of persons on belt<br />
conveyors, as outlined in this Section, shall apply when any person<br />
is transported on belt conveyors at times other than during the<br />
regularly scheduled mantrip operations.<br />
Bare pinch wires are acceptable for stopping <strong>and</strong> starting belt<br />
conveyors used to transport persons, provided that the voltage on<br />
such circuits is not more than 12 volts. A pull cord arrangement<br />
that will enable any person riding the belt to stop <strong>and</strong> start it<br />
shall be acceptable as compliance. Start switches may be located<br />
at intervals of not more than 500 feet along such belt conveyors.<br />
An official or other responsible person designated by him should be<br />
in attendance while miners are boarding or leaving belts.<br />
Ample clearance should be provided at conveyor-loadingheads <strong>and</strong> at<br />
conveyor-control panels.<br />
75.1403-6 Criteria - Self-Propelled Personnel Carriers<br />
Self-propelled track equipment should be equipped with s<strong>and</strong>ing<br />
devices capable of applying s<strong>and</strong> to all rails in either direction<br />
of travel.<br />
75.1403-7 Criteria - Mantrips<br />
The following shall be adopted as additional policy to govern the<br />
use of "scoop tractors" when transporting persons:<br />
October 2003 (Release V-34) 126