Program Policy Manual - VOLUME V - Mine Safety and Health ...
Program Policy Manual - VOLUME V - Mine Safety and Health ...
Program Policy Manual - VOLUME V - Mine Safety and Health ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
MSHA PROGRAM POLICY MANUAL <strong>VOLUME</strong> V<br />
75.605 Clamping of Trailing Cables to Equipment<br />
Section 18.40 requires insulated strain clamps or cable grips on<br />
the trailing cables of permissible machines, except that mesh-wire<br />
cable grips (e.g. Kellems grips) are not permitted on trailing<br />
cable reels. Where mesh-wire cable grips are permitted, they<br />
shall be installed in accordance with the following:<br />
1. Sufficient slack shall be provided in the trailing cable<br />
between the machine <strong>and</strong> the cable grip.<br />
2. A hose clamp shall be provided on the outby end of the<br />
cable grip to prevent slippage along the cable jacket.<br />
A length of flame-resistant hose conduit is acceptable for<br />
insulating a metal strain clamp.<br />
75.606 Protection of Trailing Cables<br />
Trailing cables shall be placed away from roadways <strong>and</strong> haulageways<br />
where they might be run over or damaged by mobile equipment.<br />
Where the method of mining requires that trailing cables cross<br />
roadways or haulageways, the cables shall be securely supported<br />
from the mine roof, or if the height of the coal seam does not<br />
permit hanging the cables, the cables shall be installed in a<br />
trench cut into the mine roof or mine floor. A substantial bridge<br />
for the equipment to pass over the cables is also acceptable if,<br />
in the opinion of the inspector, the cables are adequately<br />
protected.<br />
February 2003 (Release V-33) 71