2.0 Mb DTI/PRI Administration and Maintenance Guide Book ... - Home

Chapter 13 — ISDN Feature Implementation Page 1057 of 1536
ACOD x...x The Access Code for the trunk route.
The Access Code must not conflict with the numbering
plan.
...
MCTS YES Enable MCT signaling.
...
- MCTM (0)-30 Malicious Call Trace disconnect delay timer (this timer
overrides the T306 timer for calls originating or terminating
on sets with MCT Class of Service).
- MTND (NO) YES (Do not) apply a Malicious Call Trace disconnect delay for
tandem calls.
LD 14 - Configure the Australia ETSI ISDN PRI2 trunks.
Prompt Response Description
REQ NEW
CHG
TYPE TIE
COT
DID
Add new data.
Change existing data.
TIE trunk data block.
Central Office Trunk data block.
Direct Inward Dialing trunk data block.
Note: Must match TKTP defined in LD 16.
TN c u Loop and channel for digital trunks, where:
cu = card and unit (Option 11C).
CUST xx Customer number, as defined in LD 15.
RTMB 0-127 1-510 Route number and member number (Option 11C).
...
Option 11C 2.0 Mb DTI/PRI Administration and Maintenance guide