2.0 Mb DTI/PRI Administration and Maintenance Guide Book ... - Home

Page 738 of 1536 Chapter 3 — DPNSS1/DASS2 features description and implementation
As a consequence, the effect on an incoming EI request (ICL included) on a
set with a PLEV configured is the following:
Table 61
Effect of ICLs on different PLEVs for an EI request
ICL in the incoming EI
request
1 1
2 1-2
3 1-3
LD 12 – Define a BKI/Intrusion key on the Attendant Console:
Prompt Response Description
REQ CHG Change.
TYPE 1250 or 2250 Attendant Console type.
Feature operation
From Attendant Consoles the Executive Intrusion feature operates in a similar
manner to that of the existing Attendant Break-In feature as follows:
1 The attendant dials the destination DN.
2 The attendant receives busy tone.
3 The attendant presses the Break-In (BKI) key on the console.
4 If the ICL on the Attendant Console is higher than the IPLs of both the
requested and the unrequested parties, a conference is established
between all three parties.
5 After the unrequested party disconnects, the attendant can extend the
incoming call to another DN if desired.
553-3011-315 Standard 10.0 May 1999
PLEVs for which Executive
Intrusion is allowed
TN c u Terminal Number for the Option 11.
KEY xx BKI Define key xx as the BKI key.